1. Take the clip assembly and remove the two screws from the underside.
2. Place the clip assembly onto the base assembly and press down firmly until the parts come together. You may find it easier to do this on a flat surface. It should look like this:
3. Now, fit the two screws through the base assembly into the clip assembly, tighten gently until the two pull together.
4. Next, take the wedge and remove the 2x M4 screws:
5. Place the clip assembly and base on top of the wedge, making sure the phone slot is at the narrower side of the wedge. Fit the 2x M4 screws from the top down and tighten gently until the two nip up. It should now look like this:
6. Ensure the dash is clean, then wipe the dash with an alcohol wipe or IPA cleaner to ensure good adhesion.
7. Remove the protective film from the 3M tape, then carefully position the holder onto the dash. This is best done from above, lowering the assembly down into place vertically.
8. Apply firm pressure for 15 seconds.
I hope this helps. Any questions, please let me know. Thanks again for your order and I hope you enjoy using it!